EIBENSTOCK EHR 18.1S SET Instrucciones De Servicio página 15

Tool Protection
Wrong handling can cause damages on the tool. Therefore, please always
observe the following instructions:
Only use stirring rods with M14 - internal thread which are recommended by
the producer.
Please consider the max. basket diameters.
Do not allow blocking of the tool.
Only use original accessories made by EIBENSTOCK.
Switching on and off
2
Note: For safety reasons, the on/off switch cannot be locked; it must remain
pressed during the entire operation.
To switch off the power tool, release the on/off switch.
The Stirrer EHR 18.1 S is equipped with an electronic switch. With this
switch the speed can be regulated according to the pressure on the button.
Only use the electronic switch when you want to start or stop the machine
in order to avoid material splashing around. A permanent use with reduced
speed can cause an overload because the motor then gets less cooling air
and therefore the machine will be overheated much faster.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only be appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an
electric specialist. Due to its design, the machine needs a minimum of care
and maintenance.
observed:
▪
Always keep the power tool and the ventilation slots clean.
▪
During work, please pay attention that no particles get inside the
machine.
▪
In case of failure, a repair has to be carried out by an authorised
service workshop.
To start the power tool, first press the lock-off
1
button (1), then press the on/off switch (2) and keep
it pressed.
However, the following points always have to be
15