Hisense HRF209N6CSE Manual De Operación Del Usuario página 10

Connect Water Line to Refrigerator
IMPROTANT: If you turn the refrigerator
on before the water is connected, turn
off the ice maker.
.
1 You may need to purchase below
items to complete this connection.
And you may find these items sold
as a kit at a local hardware store.
a b c
a
b
c
2. Unplug refrigerator or disconnect
power.
3. Close shut off value.
4. Thread a 1/4 " compression nut and
ferrule (sleeve) onto the free end and
of 1/4" water line.
5. Insert the free end and of the 1/4" water
line into the brass fitting attached to the
water inlet on the back of the refrigerator.
6. Slide the 1/4" compression nut over the
ferrule (sleeve) and screw the 1/4"
compression nut onto the brass ftting.
7. Comfirm 1/4" water line is secure by
gently pulling on it.
8. Turn on water supply and check for leaks,
and correct any leaks.
Ferrule (Sleeve) -1 pcs
1/4" Compression Nut - 1 pcs
1/4" Water Line - 1 pcs
c
1/4" Water Line
b
1/4" Compression Nut
a
Ferrule(Sleeve)
d
Brass Fitting
e
Water Inlet
Note:
Use only the new tubing supplied with
the refrigerator. Old tubing should not
be used.
After connected to the water supply line,
please open the water valve to flush the
filter for 5 minutes before use. The initial
dark discoloration of water is normal.
When you connect the water line to the
appliance and press the lever of the
dispenser for the first time, it is normal
that there will be a sound of exhaust
coming out from the appliance.
WARNING!
1. The water line must be
connected to the cold water
pipe. If it is connected to the hot
water pipe, it may cause the
purifier to malfunction.
2. Avoid contamination of pipes
during installation.
3. Connect to potable water
supply only.
10