Intended Use - Ryobi RLL18 Manual De Instrucciones

Safety, performance, and dependability
have been given top priority in the design
of your lantern.

INTENDED USE

The lantern is intended for general
illumination. Do not use the product in
wet conditions.
Do not use the product for any other
purpose. Use of
operations different from intended could
result in a hazardous situation.
LANTERN SAFETY WARNINGS
■
The light source of this luminaire
is not replaceable. When the light
source reaches its end of life the
whole luminaire shall be replaced.
■
Use only with recommended battery
pack and charger. Any attempt to
use another battery pack will cause
damage to the product and could
possibly explode, cause a fire, or
personal injury.
■
Do not disassemble the product.
■
If wrapped or in contact with fabrics,
the lens can produce sufficient heat
to melt some fabrics. To avoid serious
personal injury, never allow the lens
to come in contact with anything.
■
Do not place the product or battery
pack near fire or heat. This will
reduce the risk of explosion and
possible injury.
■
Remove the battery pack before
starting any work on the product.
■
Do not store the product in a damp
or wet location, or in a location where
the temperature may reach or exceed
40°C. For example, inside sheds,
vehicles, or metal buildings in the
summer.
the product for
BATTERY SAFETY WARNINGS
■
To reduce the risk of fire, personal
injury, and product damage due
to a short circuit, never immerse
your tool, battery pack, or charger
in fluid or allow fluid to flow inside
them. Corrosive or conductive fluids,
such as seawater, certain industrial
chemicals, and bleach or bleach-
containing products, etc., can cause
a short circuit.
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance
with local and national provisions and
regulations.
Follow all special
on packaging and
transporting batteries by a third party.
Ensure that no batteries can come in
contact with other batteries or conductive
materials while in transport by protecting
exposed connectors with insulating, non-
conductive caps or tape. Do not transport
batteries that are cracked or leaking.
Check with the forwarding company for
further advice.
KNOW YOUR PRODUCT
See page 64.
1. Hanging bracket
2. Power button
3. USB charging port
4. Battery port
5. Operator's manual
6. Battery pack
7. Charger
MAINTENANCE
■
Use only original accessories and
spare parts. Should components
need to be replaced which have
not been described, please contact
Original Instructions
EN
FR
DE
ES
IT
NL
requirements
PT
labelling when
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL
3