Cleaning Instructions - Sunbeam Products Mr. Coffee ART0000883319 Manual Del Usuario

CLEANING INSTRUCTIONS

Remember to always clean your Burr Grinder before using it for the first time.
Then, to ensure optimal function and durability, clean it regularly following
these simple steps:
1. Always unplug your Burr Grinder after use and before cleaning.
2. Remove Grind Chamber by pulling it out of the unit.
3. Remove Bean Hopper Lid and Protective Burr Cover. To remove the
Protective Burr Cover, twist the knob located inside the Bean Hopper
counterclockwise to unlock (towards the unlock symbol), then pull cover
out.
4. Clean the Bean Hopper with a damp cloth or paper towel. Do not immerse
or run water to clean.
5. Wash Bean Hopper Lid, Protective Burr Cover, Grind Chamber and Lid
with warm soapy water.
CAUTION! Never use abrasive cleaners, steel wool pads, or other abrasive
materials. Unit is not dishwasher safe.
6. The upper burr inside the bean Hopper is removable to help you clean
and remove any coffee beans or foreign objects that might get stuck
between the burrs. To remove, make sure the Protective Burr Cover has
been removed. Then, twist the grip area on the top burr clockwise. Pull
upper burr out and use a brush to clean it.
7. Dry all pieces thoroughly.
8. Place Lid back on Grind Chamber and then install into unit by pushing to
lock into place.
9. Insert top burr in the Bean Hopper and lock into place by twisting the grip
area counterclockwise.
10. Place Protective Burr Cover and lock by turning knob located inside the
Bean Hopper clockwise (towards the lock symbol). Place the Bean Hopper
Lid.
TROUBLESHOOTING YOUR MR. COFFEE
BURR GRINDER
Your MR. COFFEE® Burr Grinder has been carefully designed to give you
many years of trouble-free service. In the unlikely event that your new Burr
Grinder does not operate satisfactorily, please review the following potential
problems and try the steps recommended BEFORE you call an Authorized
Sunbeam Service Center
7.
PROBLEM
THE UNIT DOES
NOT GRIND
THE COFFEE
GROUNDS
PRODUCED ARE
INSUFFICIENT
THE SIZE OF
GROUND COFFEE
PARTICLES IS NOT
CONSISTENT
®
PROBABLE CAUSE SOLUTION
• Grind Chamber is not in • PLACE GRIND CHAMBER IN
position PROPER POSITION
• Start button has not • PRESS AND HOLD BRIEFLY
been pressed START/STOP BUTTON
• Unit is unplugged • PLUG UNIT IN
• There's a power outage • WAIT FOR POWER TO BE
• Motor has overheated, RESTORED
thermal fuse is open • UNPLUG UNIT FOR AT LEAST
• Hopper Chute Clogged AN HOUR THEN PLUG BACK
(or Blocked) IN ANS USE AS NEEDED
• Protective Burr Cover is • REMOVE BURRS TO CLEAR
not inserted inside the BLOCKAGE
grind chamber • INSERT PROTECTIVE BURR
COVER INSIDE THE BEAN
HOPPER AND TWIST KNOB
CLOCKWISE TO LOCK IN THE
COMPONENT
• Grinder setting is • SET GRINDER SETTING
incorrect CORRECTLY
• Insufficient amount of • ADD BEANS TO HOPPER
whole beans in hopper • PLACE GRIND CHAMBER IN
• Grind Chamber moved PROPER POSITION
out of position during • UNPLUG UNIT AND
operation CAREFULLY DISLODGE
• There is a foreign object FOREIGN OBJECT BY
between the two Burr REMOVING THE UPPER
BURR, FOLLOW CLEANING
INSTRUCTIONS ON PAGE 7.
• There's a foreign object • UNPLUG UNIT AND
between the two Burrs CAREFULLY DISLODGE
• Grind setting is not FOREIGN OBJECT
correct • USE GRIND SIZE SELECTOR
TO CHOOSE THE CORRECT
GRIND SETTING
8.