Publicidad
Idiomas disponibles
Idiomas disponibles
USING THE RAMP AS A
ONE PIECE HINGED RAMP
RAMP SECTIONS CAN BE BOLTED TOGETHER USING THE SUPPLIED
HINGES TO FORM A CENTER FOLDING 1-PIECE RAMP.
1. Using a 9/16" wrench, remove two nuts and bolts from one side of
hinge. Note how plates are assembled (FIG 1). Do not disassemble
1/2" main bolt on hinge. The factory setting for the main bolt is snug
but loose enough to permit movement of the hinge.
2. Lay ramp sections upside down.
3. Assemble one side of hinge to inside of ramp.
4. Tighten the 3/8" bolts to 220-240 in-lbs. (FIG 2).
Note: Ramp will fold out to 165 deg. angle (angled for loading clearance).
5. Repeat on all 4 sides.
•
Maximum height when used as one piece ramp is 36 in.
DO NOT EXCEED MAXIMUM HEIGHT.
•
Capacity for assembled ramp = 600 lbs.
1
2
PAGE 3
3480400_RevB • Questions? (800) 234-6992 • ReeseBrands.com
Tighten to 220-240 in-lbs.
Tighten to 220-240 in-lbs.
Publicidad
