Important - Kenmore KKFP11CB Manual De Uso Y Cuidado

PREPARING TO USE
Before using the food processor, wash all parts except the Base in hot, soapy water. Rinse dry.
These parts can also be placed in the dishwasher on the top rack. Do not put in or near the utensil
basket.
CAUTION - Blades are sharp. Handle carefully.
CAUTION
NEVER place food processor's motor/base in water or other liquids.
NOTE - DO NOT attempt to chop ice in this Food Processor; it will damage the Bowl and
dull the Chopping Blade. This unit will not whip cream, beat egg whites to a desirable
volume, grind co ee beans, spices or other items with high oil content, or slice or shred
hardboiled eggs, marshmallows, or soft cheeses.
IMPORTANT - For your protection, this unit has an interlock system. The Processor will
not operate unless the Bowl is properly locked onto Base and Cover is properly locked
onto the Bowl. Do not attempt to operate the unit without the Bowl, Bowl Lid, and
Food Chute Lid correctly in place.
ASSEMBLING YOUR FOOD PROCESSOR
ASSEMBLY
1. Make sure the Control Knob is in the OFF position and the power cord is unplugged.
2. Be sure Food Processor base is on a at, dry, clean, stable surface before you begin processing.
3. To assemble, put the Bowl on the Base by aligning the Bowl handle with the Unlock icon on the
base. Lock the Bowl onto the Base by turning the Bowl counterclockwise until it clicks into place.
Once locked, the Bowl handle will face front and center (see Fig. 1).
NOTE - There is only one position for the Bowl to lock onto the Base. The unit will not
operate if the Bowl does not lock onto the Base.
Fig. 2
Fig. 2a
Fig. 2a Fig. 2b
4
ASSEMBLING YOUR FOOD PROCESSOR
4. Place the Bowl Cover onto the Bowl. Align the arrow on the Cover with the Unlock icon on the
Bowl (see Fig. 2 , 2a and 2b). Turn the Cover counterclockwise towards the center front until it
clicks.
NOTE - There is only one position for the Bowl Cover to lock onto Bowl. The unit will not operate
if the Bowl Cover does not lock onto the Bowl, or if the Large Food Pusher is not inserted into the
Oval Food Chute.
5. There is a Food Pusher Assembly consisting of a Large and Small Pusher. Align the raised seam
running down the back of the Large Pusher with the slot in the Interlock Start Switch. Insert the
Large Pusher into the Oval Food Chute. Then insert the Small
Pusher into the Circular Food Chute in the Large Pusher. See Fig. 3 and 3a.
Fig. 3
BLADE ASSEMBLY
1. Place the Chopping
Blade on the Disk Drive
Adaptor as shown.
NOTE - Be sure the
words "THIS SIDE UP"
are facing up.
2. Rotate the Chopping
Blade clockwise until
it locks in place.
5
Fig. 3a