VONROC GP529AC Traducción Del Manual Original página 10

EN
TROUBLE SHOOTING GUIDE
Problem Cause
Pump does not No mains supply
start
Pump not switched
on
Check the current
pressure on the
pressure gauge
Blocked pump
wheel
Pump is active but The pump is not
no water is being fully filled with
delivered (after water
being started
for more than 5
minutes) Air in the suction
hose
Water level is too
low
Suction hose, foot
valve, pre-filter or
pump is blocked
Insufficient Incorrect pump type
pressure
The suction hose
is too long or with
too many bends,
suction hose
diameter is not
selected as
required
Suction hose, foot
valve, pre-filter or
pump is blocked
The outlet hose is
incorrectly or in-
correctly installed
10
Pump will not
start or stops
Remedy
during use.
Check mains supply
Switch on pump
Pump switched
off after short
When the pressure
operating periods
is below the switch-
on pressure of 1.4
bar will the device
switch on and opera-
te until reaching the
switch-off pressure
of 2.6 / 2.8 bar.
ENVIRONMENT
Turn the engine shaft
with screwdriver
through the fan cover
Re-fill the pump
with water and
check the suction
Only for EC countries
hose foot valve
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/
Check sealing of
EU for Waste Electrical and Electronic Equipment
various joints of
the suction hose
and its implementation into national right, power
tools that are no longer usable must be collected
Adjust installation
separately and disposed of in an environmentally
height of the pump
friendly way.
(< 8 m)
WARRANTY
Clean suction hose,
foot valve, pre-filter
or pump
VONROC products are developed to the highest
quality standards and are guaranteed free of
Select suitable pump
defects in both materials and workmanship for the
25mm, 32mm
period lawfully stipulated starting from the date of
or 38mm (inner
original purchase. Should the product develop any
diameter) suction
failure during this period due to defective material
hose must be used
and/or workmanship then contact VONROC directly.
to achieve maximum
flow rate. Make the
suction hose shorter
The following circumstances are excluded from this
guarantee:
Clean suction hose,
• Repairs and or alterations have been made
foot valve, pre-filter
or attempted to the machine by unauthorized
or pump
service centers;
Check the outlet
• Normal wear and tear;
hose and connecti-
• The tool has been abused, misused or
ons. The larger the
improperly maintained;
diameter of the hose
• Non-original spare parts have been used.
and the hose con-
nection, the greater
the flow. The lower
This constitutes the sole warranty made by compa-
the delivery height,
ny either expressed or implied. There are no other
the greater the flow.
Thermal overload
safety switch has
activated
Power has tripped
Water too hot
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
WWW.VONROC.COM
Disconnect from
the power supply,
leave for 5 minutes
and clean suction
hose, foot valve,
pre-filter or pump
Check fuses and
electrical connec-
tions
Ensure that the wa-
ter temperature has
not exceeded the
maximum of 35°C