BLS ZERO 32 Active Serie Manual Del Usuario página 8

ENGLISH - EN
ZER0 32 ACTIVE SERIES
DESCRIPTION / BLS filtering half masks are Category III PPE certified in
accordance with Regulation (EU) 2016/425, meeting the standards of EN
149:2001+A1:2009. Number 0426 identifies the Notified Body ITALCERT
S.r.l.-Viale Sarca, 336 - 20126 Milan (Italy) that examined the PPE at the design
stage and is in charge of the annual inspection according to Regulation (UE)
2016/425. These devices can be used to protect users from solid particulates,
nonvolatile liquids, and mists (pay attention to product use limits: FFP1 up to
4xTLV, FFP2 up to 12xTLV, FFP3 up to 50xTLV). Models featuring the activated
carbon layer allow greater comfort in the presence of unpleasant odors caused
by volatile substances in concentrations below the TLV.
The declarations of conformity are available in the reserved area of
www.blsgroup.com
WARNINGS / 1) Wearing the product in the wrong way will compromise its
functionality; the user must be trained in the proper use of the device before
use. 2) Check the product for damage before use; do not modify or alter the
device in any way. 3) This product does not protect against gases and vapors
for which appropriate equipment (half masks and full masks with gas filters) is
required; ensure that the product provides the appropriate level of protection
for the type and concentration of contaminants in the work environment. 4) Do
not use in an environment with insufficient oxygen content (< 17%). 5) Do not
use as an escape device; BLS protective devices are not designed according
to Directive 2014/34/EU. 6) Do not use when contaminant concentrations are
immediately dangerous to health. 7) The devices should be discarded after the
first use if used for pathogen protection. The product should be replaced at
the first sign of deterioration or if breathing resistance becomes excessive. 8)
We do not recommend use in the presence of certain physical characteristics
(beard or long sideburns) that compromise the face seal of the respirator. 9)
This product is not flame resistant and should not be used in areas with open
flames. 10) Dispose of in accordance with local regulations. 11) Disinfect hands
before and after any direct contact with the mask; handle the device being
careful not to come into contact with surfaces that may be contaminated. 12)
Reusable filtering facepieces (R) should be cleaned before being stored in a
clean and dry place. For cleaning R-marked products, use a disinfectant of the
8