Security Information - XTREM CFHD5000 Manual De Instrucciones

W C
ATERPROOF ASE
Before sealing the waterproof case, keep the camera housing's rubber seal clean, a single hair or grain of sand can cause
a leak. You can test by closing the case without inserting the camera. Submerse the case completely in water for about a
minute. Remove the case from the water, dry off its exterior with a towel, and then open the case. If the interior is dry,
the case is safe for use under water.
After use in salt water you will need to rinse the outside of the housing with fresh water and then dry. This will prevent
corrosion of the hinge pin and salt buildup in the seal, which can cause failure.
To clean the seal, rinse in fresh water and shake dry (drying with a cloth may cause lint to compromise the seal).
Re-install the seal into the grooves in the backdoor of the housing.
S I
ECURITY NFORMATION
This device was designed and built to guarantee your safety. The safety mechanisms implemented in the product will
protect you if you observe the following installation, operation and troubleshooting procedures:
Please carefully read and follow the following instructions before handling and installing your device,
Keep these instructions for further reference.
G
ENERAL
Don't shake, or it may lead to damage to the product.
Only use components and accessories (power supply...) recommended by the manufacturer,
The illustrations of the product may vary from actual product.
4