Connecting Via Bluetooth - Corsair K100 AIR Manual De Instrucciones

CONNECTING VIA BLUETOOTH

1. Initiate Bluetooth pairing on the host device such as a phone or tablet (Bluetooth 4.0 or higher)*
2. Start Bluetooth host pairing on the keyboard, up to three devices can be paired (see below)
3. Input the code from the Bluetooth device screen on the keyboard if requested
4. When pairing completes, the wireless indictor (D) turns solid blue/cyan/magenta for 3 seconds
SHORTCUT
FN + (Press) Switch to Bluetooth host 1 mode
FN + Start Bluetooth host 1 pairing*
(Hold)
Switch to Bluetooth host 2 mode
FN + (Press)
FN + (Hold) Start Bluetooth host 2 pairing*
FN + Switch to Bluetooth host 3 mode
(Press)
Start Bluetooth host 3 pairing*
FN + (Hold)
*Bluetooth host device must support standard keyboard HID input.
CONNECTING VIA USB WIRED
1. Connect the keyboard via USB cable to a USB 3.0 Type-A port or better
2. The keyboard will automatically switch to USB wired mode
3. Go to iCUE device settings to select up to 8,000Hz hyper-polling with
CORSAIR AXON*
*Polling rates higher than 1,000Hz are not support by Xbox or PlayStation consoles.
NOTE: Wireless modes can be switched to at any time by pressing a wireless shortcut. Pressing the same
shortcut again will switch back to USB wired mode.
WIRELESS
®
FUNCTION
3
STATUS INDICATION
Connected Solid Blue (3 sec)
Disconnected Pulsing Blue
Pairing Blinking Blue
Connected Solid Cyan (3 sec)
Disconnected Pulsing Cyan
Pairing Blinking Cyan
Connected Solid Magenta (3 sec)
Disconnected Pulsing Magenta
Pairing Blinking Magenta
INDICATOR