LumaPro 436R33 Manual De Instrucciones página 6

LumaPro Operating Instructions
Wiring (Continued)
3. The FIG. 14 and FIG.15 demonstrate the interior wiring of different configurations in
the driver compartment (When need to remove or replace any component in the driver
compartment, please refer to the below wiring FIG. 14 and FIG. 15 and base on the
actual condition, resume using the fixture by wire connecting).
4. Disconnect the AC power supply to prevent electric shock when making wiring or
installation, removing or replacing any component in the fixture. Make sure to use
WAGO connector properly to ensure proper and secure wiring, make sure of correct
wiring before restoring power supply to light up the fixture.
Fixture wiring diagram:
1. FIG.14a is for wirings when only one LED driver is used in driver compartment,
no options.
436R33, 446M61, 446M57, 446M58
LED Area Light
Fixtures
6