sunjoe 24V-LGT500-CT Manual Del Operador página 8

If any parts are damaged or missing, please call the Snow Joe
+ Sun Joe customer service center at 1-866-SNOWJOE
®
(1-866-766-9563) for assistance.
Operation
m
WARNING!
Do not direct the light beam at persons
or animals and do not stare into the light beam yourself (not
even from a distance). Staring into the light beam may result in
serious injury or vision loss.
m
WARNING!
Do not allow familiarity with products to
make you careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
m
WARNING!
Do not use any attachments or accessories
not recommended by the manufacturer of this product, as they
may result in serious personal injury.
TOOL ONLY
BATTERY + CHARGER SOLD SEPARATELY
In order to operate this cordless lantern, you will need a
24V iON+ System battery and charger. See page 11 for
battery and charger options and specifications, or visit
sunjoe.com for more information.
1. Remove the battery compartment cover, then insert the
battery pack into the battery compartment until the push
lock buttons click into place (Fig. 4).
2. Close the battery compartment cover. Make sure the
latches on each side of the cover snap into place and the
battery pack is secured before beginning operation.
Fig. 4
Battery
compartment
®
Push lock button
Latch
Battery
compartment
cover
8
m
WARNING!
Battery products are always in operating
condition. Therefore, remove the battery pack when the
product is not in use or when carrying at your side.
Turning ON/OFF (Fig. 5)
The lantern has five settings: daylight, warm white, combined,
warning light and off.
• Daylight: Press the power button once.
• Warm White: Press the power button twice.
• Day + Warm Light Combined: Press the power button a
third time.
• Warning: Press the power button a fourth time.
• Off: Press the power button a fifth time.
NOTE: Long-press the power button to adjust the brightness
on each setting.
Fig. 5
Power
button
Hanging the Lantern
m
WARNING!
Only hang the lantern in an area where
no electrical wires, utility cables, pipes, or other obstructions
are located. Contact your local utility company or a qualified
electrician if you are unsure. Do not hang the lantern from an
electrical power cord. Ensure the lantern is securely installed to
prevent hazard from falling. Failure to follow these instructions
can result in electrocution, electrical shock, or other serious
personal injury.