VONROC GS503AC Traducción Del Manual Original página 6

EN
• This appliance is not intended for use by per-
sons (including children) with reduced physical,
sensory or mental capabilities, or lack of expe-
rience and knowledge, unless they have been
given supervision or instruction concerning use
of the appliance by a person responsible for
their safety. Children should be supervised to
ensure that they do not play with the appliance.
WARNING: After switching off the machine,
the cutting cylinder continues to rotate for a
few more seconds.
• Before use check the supply and extension
cord for signs of damage or ageing. If the cord
becomes damaged during use, disconnect the
cord from the supply immediately.
• DO NOT TOUCH THE CORD BEFORE DISCONNEC-
TING THE SUPPLY.
• Not to connect a damaged cord to the supply or
touch a damaged cord before it is disconnected
from the supply. A damaged cord can lead to
contact with live parts.
• Do not use the shredder if the cord is damaged
or worn.
• Read the instructions carefully. Be familiar with
the controls and proper use of the equipment.
Avoid using the machine in bad weather condi-
tions especially when there is a risk of lightning.
Always wear substantial footwear and long
trousers while operating the machine.
• Keep children and pets well away from the work
area and never allow children to use this applian-
ce or touch the main power cord or extension cord
at any time. When not in use, keep this appliance
stored in a safe place out of reach of children.
WARNING: In order to reduce the risk,
disconnect the plug from the supply power,
only use recommended accessories as
required, otherwise personal injury may
result.
• Wear ear protection and safety glasses at all
times while operating the machine
• Wear a dust protection if the shredding action
causes the raising of dust or particles.
• Dress sensibly for the job in hand - no loose
clothing that could get caught in the moving
parts of the appliance.
6
• Pull long hair back out of the way and wear a
protective hat.
• Only operate the machine in open space (e.g.
not close to a wall or other fixed object) and on
a firm, level surface.
• Do not operate the machine on a paved or gravel
surface where ejected material could cause injury.
• Thoroughly inspect the shredder for loose or
damaged parts before each use. Do not use the
shredder until adjustments or repairs are made.
• Replace damaged or unreadable labels.
• Only use a waterproof, fully unwound extension
cable suitable for outdoor use.
• This appliance is for outdoor use only.
• Do not expose this appliance to rain.
• Use the shredder only in daylight or good artifi-
cial light.
• Never leave the appliance unattended.
• Do not use the appliance in an area where it
could cause an explosion or fire - keep it away
from flammable liquids and gases.
• Guard against electric shock - prevent body
contact with earthed or grounded surfaces i.e.
metal gates, posts or other metal objects in the
work area.
• Never pull the appliance by its power cord.
Wheel it or carry it with two hands.
• Do not allow the power cord to lay on or across
sharp objects that might pierce the outer insu-
lation.
• Do not use this appliance if you are on strong
medication, unwell or have been drinking alcohol.
• Never attempt to put your hand inside the fee-
der hopper. If you want to push material into the
cutting chamber use the push stick.
• Before starting the machine, look into the fee-
ding chamber to make certain that it is empty.
• Keep your face and body away from the feed
intake opening.
• Do not allow hands or any other part of the body
or clothing inside the feeding chamber, dischar-
ge chute, or near any moving part.
• Keep proper balance and footing at all times.
Do not overreach. Never stand at a higher level
than the base of the machine when feeding
material into it.
• Always stand clear of the discharge zone when
operating this machine.
• When feeding material into the machine be extre-
mely careful that pieces of metal, rocks, bottles,
cans or other foreign objects are not included.
WWW.VONROC.COM