Machine Information - VONROC GS503AC Traducción Del Manual Original

EN

2. MACHINE INFORMATION

Intended use
This shredder is developed to chop up branches,
twigs and other pruning. It can easily be reduced to
wood chips for reuse. The shredder is intended for
medium to large sized private gardens. This shred-
der is for domestic use only and not for commerci-
al, industrial or trade use.
TECHNICAL SPECIFICATIONS
Model No.
Voltage
Frequency
Power
No load speed
Max. cutting diameter
Collection box capacity
Weight
Protection level
Protection type
Sound power level (Lwa)
Sound pressure level (LpA)
* The P40 operating mode means the machine
shall be operated intermittently, it was operated
intermittently until stabilization or for 30 cycles
in heating compliance test, each cycle compri-
sing a period of operation of 40s at rated power
input and a period of 60s with the machine at
no load.
** Depending on the hardness of the wood.
*** According to 2000/14/EC&2005/88/EC
(included K=3 dB(A))
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-3.
1. Feeder hopper
2. Machine body
3. Frame
4. Wheel axle
5. Washer
6. Wheel
7. Cotter pin
8. Wheel cover
8
GS503AC
230-240 V~
50 Hz
2800 W (P40)*
2980/min.
45 mm**
60 L
27 kg
IPX4
Class I
92 dB(A)***
76 dB(A), K=3 dB(A)
9. Feet
10. Collection box
11. Safety switch
12. Push stick
13. Socket
14. Power indicator
15. Function switch
16. ON switch
17. OFF switch
18. Overload protection reset
19. Counter blade knob
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Assembling the wheels and the frame (Fig. B & C)
1. Stand the machine body (2) upside down.
Attach the machine body (2) on the frame (3)
using the four screws enclosed. See figure B.
2. Push the wheel axle (4) through the two lower
holes of the frame (3).
3. Attach on each side of the axle a washer (5),
a wheel (6) and another washer (5). Then fit a
cotter pin (7) through the hole at each end of
the axle (4) and bend the cotter pins to lock the
wheels on the axle.
4. Mount the wheel cover (8) onto the wheel (6).
Assembling the feet and the collection box
(Fig. A & D)
1. Attach the two feet (9) to the frame (3) using
the two screws enclosed with a Philips screw-
driver.
2. Slide the collection box (10) with the safety
switch (11) to the front into the guide rails and
insert the box completely into the frame (3).
3. Lock the safety switch (11) in position by
pushing it upwards.
4. OPERATION
If the machine starts to vibrate abnormally
(check immediately):
- inspect for damage,
- replace or repair any damaged parts,
- check for and tighten any loose parts.
WWW.VONROC.COM