Dunsch DU10040-38C3 Instrucciones Originales página 23

- Stop the blade(s) if the machine has to be tilted for transportation when
crossing surfaces other than grass, and when transporting the machine to
and from the area to be used.
- Never operate the machine with defective guards or shields, or without
safety devices, for example deflectors and/or grass collector, in place.
- Switch on the motor carefully according to instructions and with feet well
away from the blade(s).
- Do not tilt the machine when switching on the motor, except if the
machine has to be tilted for starting. In this case, do not tilt it more than
absolutely necessary and lift only the part, which is away from the
operator.
- Do not start the machine when standing in front of the discharge
opening.
- Do not put hands or feet near or under rotating parts. Keep clear of the
discharge opening at all times.
- Do not transport the machine while the power source is running.
- Stop the machine, and remove the battery from the device. Make sure
that all moving parts have come to a complete stop.
Stop the machine, and remove the disabling device. Make sure that all
moving parts have come to a complete stop.
 whenever you leave the machine,
 before clearing blockages or unclogging chute,
 before checking, cleaning or working on the machine,
 after striking a foreign object. Inspect the machine for damage and
make repairs before restarting and operating the machine; if the
machine starts to vibrate abnormally (check immediately),
 inspect for damage,
 replace or repair any damaged parts,
 check for and tighten any loose parts.
4) Maintenance and storage
- Keep all nuts, bolts and screws tight to be sure the machine is in safe
working condition.
- Check the grass collector frequently for wear or deterioration.
- On machines with multi blade, take care as rotating one blade can cause
other blades to rotate
- Be careful during adjustment of the machine to prevent entrapment of
the fingers between moving blades and fixed parts of the machine.
- Always allow the machine to cool down before storing.
- When servicing the blades be aware that, even though the power source
GB
21