EVGA G7 1000W SuperNova Guía Rápida página 6

Installation
3. Use the screws provided with your case to install the power supply into
your computer. NOTE :
the fan facing down. However, if your case places the power supply at the
bottom of the case and there are no ventilation holes available, it may be
best to install the power supply with the fan facing up for greater efficiency
and reliability.
4. Connect the 24-Pin ATX cable to the PSU and the motherboard.
5. Connect the 4+4-Pin EPS12V cable to the motherboard.
plan on extreme overclocking
8-Pin or 4-Pin CPU power connectors,connect the second 4+4-Pin EPS12V
cable. This is only needed for heavy overclocking or for Dual CPU motherboards.
6. Connect the 6/6+2-Pin PCI-E cables to your graphics card(s).
NOTE 1 : Do not attempt to plug an 8-Pin PCI-E cable into a 6-Pin connector
without first detaching the two extra pins.
NOTE 2 : We recommend to use a single PCI-E cable to connect per port on
graphic cards if your video card requires high power such as equipped with
more than 2 PCI-E connectors 6pin + 8pin and 8pin + 8pin.
7. Connect SATA power cables to all data drives or optical drives (hard drives,
solid state drives, optical drives).
8. Connect the peripheral "Molex" 4-Pin connectors for fans, pumps, legacy
components and other devices/adapters.
9. Connect the AC power cord to your power supply and to the wall. Check all
connections to assure a solid connection and turn the power switch on the
power supply to the ON position.
It is recommended to install the power supply with
and your motherboard supports additional
(Optional) – If you
04