Q&A - EVGA G7 1000W SuperNova Guía Rápida

Q&A
Q : I see there are more than four screw holes
screws, are some missing?
A : Nothing is missing; you will only need to attach the EVGA power supply to the case with four screws. The
power supply offers more than (4) holes to
Q : My EVGA Power Supply includes (2)
A : Motherboards only require (1) 4+4 or 8-Pin EPS
connection on the motherboard may be found for
motherboard supports dual 4+4-Pin EPS connections, please refer to your
for details on the proper function and power of the EPS connections.
Q : What is the ECO Thermal Control
A : The ECO Thermal Control System, when enabled, allows the fan on your EVGA power supply to shut off during
low to moderate operation loads. The EVGA power supply's fan will
based on the loading the power supply reaches. The fan will also increase in RPM when needed, based on the load
operation being requested from the components connected. This prevents unnecessary rotation,
ambient noise levels and will
Please Note : If the ECO Thermal Control is disabled the fan will always spin, even at low loads. The fan will also
increase in RPM as needed automatically, based on the power draw from connected components.
Q : What if I want to use
A : EVGA always recommends the use of direct power connections from the power supply to power all components.
Q : Does it matter which end of the cable
A : Yes, the connections going to the power supply will not have "break downs" like the EPS (CPU) has 4+4 on one
side and full 8-Pin on the other.
and connect only the same
Q : If I have an issue or a question, can I get support?
A : ALL EVGA products are backed by top tier warranties as well as technical support. Support can be reached for
your power supply at :
- USA : +1-888-881-3842
- Europe : +49 89 189 049 11
provide optimal compatibility
EPS cables
System?
increase the life span
power adapters
for my graphics card(s)/motherboard/peripherals?
I plug into the power supply?
Check each cable
''matching" cable directly to the power supply as referenced on each connector.
option 1, option 3. or contact us via email at
or by email via eu.evga.com/support
on the back of the power supply, but the packaging only offers (4)
for my motherboard, do I need to connect up both?
connection. On some models, an additional 4+4-Pin or 8-Pin
dual CPU configurations or for
of the fan due to the fan not spinning when not required.
as it is labeled appropriately to match the power supply side,
.
05
for today's varied case designs.
extreme
motherboard manufacturer's manual
automatically turn back on
support@evga.com
overclocking. If your
when needed,
reduces
.