Publicidad
INSTALLING CASE ADAPTERS
As shown below, slide the Case Adapters into the slots at the bottom
of the controller cavity until the adapter snaps into place. You should
feel a solid click that con rms the adapter is properly installed.
LEFT SIDE
Only a left side Case Adapter should be installed on the left side of
the controller. The label side should be on the bottom and not visible
when installed. You will use one of the adapters labeled L10, L15,
*
L20, L25, L30, L35, L50.
L25
R15A
*
The number from the adapter label indicates the
thickness of the bottom of the adapter (lower numbered
adapters are thinner, higher numbered are thicker).
RIGHT SIDE
Only a right side Case Adapter should be installed on the right side
of the controller. The label side should be on the bottom and not
visible when installed. You will use one of the adapters labeled
R10A, R15A, R15B, R20A, R20B, R20C, R25A, R25B, R35.
R20A
R20B
R20C
*
The letter from the right side adapter label indicates the
thickness of the back wall of the adapter ("A" is thinnest,
"B" is medium, "C" is thickest).
*
Publicidad
