Publicidad
Idiomas disponibles
Idiomas disponibles
English
READ AND
SAVE THESE
INSTRUCTIONS
Read all instructions before using
the product.
DANGER
To reduce the risk of electric shock:
Always unplug this product from the
electrical outlet before cleaning.
WARNING
To reduce the risk of burns, fire, electric
shock, or injury to persons, do not use
this fan with any Solid-State speed
control device.
This appliance can be used by children
aged from 8 years and above and
persons with reduced physical, sensory
or mental capabilities or lack of
experience and knowledge if they have
been given supervision or instruction
concerning use of the appliance in a
safe way and understand the hazards
involved by a person responsible for
their safety. Children shall not play with
the appliance.
Cleaning and user maintenance shall
not be made by children without
supervision.
SAVE THESE
INSTRUCTIONS
FOR FUTURE USE.
Electricity safety
• Do not use a damaged power plug or
loose electrical outlet.
• Do not move the product by pulling
the power cord.
• To prevent the power cord from being
damaged or deformed, do not forcibly
bend it or run it under a heavy object.
• If the electrical outlet is wet, carefully
unplug the product and allow the
electrical outlet to completely dry
before subsequent use.
• Do not handle the power plug with a
wet hand.
• Do not plug in and unplug the power
plug repeatedly.
• Unplug the product before inspection
or parts replacement.
• Remove any dust or water from the
power plug.
• Unplug the product if it is not to be
used for a long time.
• If the power cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
• Do not attempt to repair or modify the
power cord.
• This product shall only be used
together with the included power
supply unit.
• If any part is damaged, the product
should not be used.
Installation safety
• The product is only intended for
household use under normal
operating conditions.
• Do not install the air purifier near a
heating device.
• Do not use the product in wet
environments or in environments with
high humidity, such as the bathroom
or in a room with great variations in
temperature.
• Leave at least 30 cm of free space
around the product.
• Do not use the product in areas where
flammable gases or combustible
materials are used or stored.
• Do not exert excessive force or subject
the product to bumps and bangs.
• Install the product so that no obstacles
around the product block the
circulation of air.
Operation safety
• Never place the product in water.
• Do not disassemble, repair or modify
the product.
• Unplug the product before you clean
it.
• If the air purifier produces a strange
noise, burning smell or smoke,
immediately remove the power plug
from the electrical outlet and call our
Customer support.
• Do not spray any flammable materials
into the air inlet.
• Do not stick fingers or foreign objects
into the air inlet or outlet.
• Replace the filter with a new one
according to filter replacement cycles.
Product performance may otherwise
deteriorate.
• Do not push or lean against this
product since it may tip over and cause
physical injury or product malfunction.
Care Instructions
Unplug the product before cleaning.
To clean the product, wipe with a soft
moistened cloth. Use another soft, dry
cloth to wipe dry.
Vacuum-clean the pre-filter regularly.
Note!
Never use abrasive cleaners or chemical
solvents as this can damage the
product.
Fan speed control
The fan can be set to 3 different speeds
by pressing the power button multiple
times.
A long press will turn the air purifier OFF
regardless of current speed level.
The LED lamp's brightness indicates the
chosen speed level.
1x
2x
Filter replacement
When replacing the filter, it is essential
that the user proceeds as follows:
A LED light on
the control panel
indicates when you
should check your
filters.
Warning!
The power supply cord must be
disconnected during filter replacement!
1. Disconnect the power and wait until
the fan has stopped.
2. Remove the pre-filter by the finger
indent. Clean the pre-filter with
a vacuum cleaner or with water
depending on how dirty it is.
3. Remove the particle filter and handle
the used filter carefully, dispose of
the filter in accordance with local
environmental regulations in your
country.
4. Clean inside, removing all dust and
dirt.
4
3x
Publicidad
