Publicidad
Idiomas disponibles
Idiomas disponibles
5. Reconnect the power supply cord.
6. Press and hold the RESET button for 3
seconds. The reset initialises the filter
replacement cycle counter.
7. Insert the new particle filter.
8. Fix the pre-filter in place.
• Wash your hands thoroughly after
replacing the filter.
Technical specifications
Model: UPPÅTVIND air purifier
Type: E2111
Input: 24V DC, 0.8 A, 19W
Dimensions:
280 x 225 x 125 mm (HxWxD)
Weight: 1.6 kg
Filter: Filter for particle removal.
• Operational temperature:
10 °C to 40 °C (50 °F to 104 °F).
• Humidity when operational:
10-60% RH
(Recommended operational
humidity: 40-60% RH)
Technical data PSU
Type: ICPSW24-19-1
ICPSW24-19-1A
Input: 100-240 VAC, 50/60 Hz, 0.4A
Output: 24.0V DC, 0.8 A, Max 19.0W
Indoor use only
Manufacturer: IKEA of Sweden AB
Address:
Box 702, SE-343 81 Älmhult, SWEDEN
Filter cleaning and replacement cycles
Filter
Pre-filter
Particle filter
* The recommended filter replacement cycles may differ depending on
the operating environment.
Run modes with filter for particle removal.
Level
Noise (Spl)
I
31 dB(A)
II
47 dB(A)
III
55 dB(A)
This device complies with Part 15 of
the FCC Rules.
This device contains licence-exempt
transmitter(s)/receiver(s) that comply
with Innovation Science and Economic
Development Canada's licence-exempt
RSS standard(s).
Operation is subject to the following two
conditions:
(1) this device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation of the device.
WARNING:
Any changes or modifications to this
unit not expressly approved by the
party responsible for compliance could
void the user's authority to operate the
equipment.
NOTE:
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation.
This equipment generates, uses and
can radiate radio frequency energy and,
if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does
cause harmful interference to radio
or television reception, which can be
determined by turning the quipment off
and on, the user is encouraged to try to
correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
cycles
method
Every 2~4 weeks
Cleaning
Every 6 months
Replacement
CADR
31 m³/h
60 m³/h
95 m³/h
Power
2.4W
4.5W
8.0W
• Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
The crossed-out wheeled bin symbol
indicates that the item should be
disposed of separately from household
waste. The item should be handed in
for recycling in accordance with local
environmental regulations for waste
disposal. By separating a marked item
from household waste, you will help
reduce the volume of waste sent to
incinerators or land-fill and minimize
any potential negative impact on human
health and the environment. For more
information, please contact your IKEA
store.
5
Publicidad
