EGAmaster 66508 Manual De Instrucciones página 29

APPLICATIONS
You may use this product for the purposes listed below:
Driving screws with screwdriver bits
Light-duty drilling
CHARGING
See Figure 1.
When charging the screwdriver, a red charge light will
Illuminate solid on the handle of the screwdriver. This red
charge light will go off when the screwdriver is fully charged.
Insert charger plug into input jack making sure it is
properly connected.
Charger can be used with normal household current of
100~240 V, AC only, 5.0~60 Hz
Connect charger to power supply.
After normal usage, a minimum of 9 hours of charging
time is required to fully recharge the screwdriver.
Do not place charger in an area of extreme heat or cold.
It will work best at normal room temperature.
Remove the product from the charger once it is fully
charged and ready for use.
OPERATION
WARNING:
Battery products are always in operating condition.
Therefore, the switch should always be locked when not
in use or carrying at your side.
STICK/PISTOL POSITION
See Figures 2 - 3,
The screwdriver can be used as a stick screwdriver or a
pistol screwdriver. A pivot locking button is located on the
top of the screwdriver.
To place the screwdriver in stick position: Hold in normal
operating position, press pivot locking button down and twist
front housing fully to the right.
To place the screwdriver in pistol position: Hold in normal
operating position, press pivot locking button down and twist
front housing fully to the left.
DIRECTION OF ROTATION SELECTOR (FORWARD/REVERSE/CENTER LOCK)
See Figure 4,
The direction of bit rotation is reversible and is controlled
by a selector located on the rear of the handle. With the
screwdriver held in normal operating position, the direction
of rotation selector should be positioned fully upward for
29