Bestway 58500E Manuel De Instrucciones página 13

NOTE:
• Be sure all provisions for wastewater disposal meet applicable local,
state or national codes. Do not discharge water where it will cause
flooding or damage.
• When the Control Valve is set to the Backwash, Rinse, or Drain
position, water will discharge from Port D on the Control Valve.
• Do not switch on or operate the sand filter with the Control Valve set to
the Closed function or it will seriously damage the sand filter.
• Do not set the Control Valve between two functions, or it will lead to
leaking.
• To avoid water leakage, screw the Port D Cap onto the Control Valve
Port D before operating the filter or circulate function.
AIR RELEASE
Press down the control valve handle and wait untill the water flow from Port D
to release the air.
NOTE:
It is important to repeat this operation every time you start the
pump after winterizing, maintenance and backwashing the sand bed.
FIRST TIME USE INSTRUCTIONS
Backwash and Rinsing must be performed to prepare the pump for its first use
and to wash the sand.
CAUTION:
1. Press down on the Control Valve handle and rotate to the Backwash function.
2. Plug in and run the sand filter for 3-5 minutes, or until the water runs clear.
3. Switch off the sand filter and set the Control Valve to the Rinse function.
4. Switch on the sand filter and run the sand filter for 1 min. This circulates water
backwards through the sand filter and drains water out Port D.
5. Switch off the sand filter. Set the Control Valve to the Closed function.
6. Top up pool water if required.
IMPORTANT:
removes water from the pool, which you'll
need to replace.
Switch off the sand filter immediately if water
levels near the pool's Inlet and Outlet valves.
DO NOT DRY RUN THE SAND FILTER
This procedure
Backwash
13
Rinsing