Important - Bestway 58500E Manuel De Instrucciones

ASSEMBLY
1. Carefully remove all components from the package and check to
ensure nothing is damaged. If equipment is
damaged, immediately notify the retailer from
where the equipment was purchased.
2. The sand filter should be placed on solid, level
ground, preferably a concrete slab. Position the
sand filter so the Ports and Control Valve are
accessible for operation, servicing and winterizing.
3. The sand filter to be vertically fixed on ground or a certain pedestal
made of wood or concrete before use to prevent the sand filter from
accidentally falling. Fully assembled sand filter will exceed 18 kg. The
mounting holes should be 8 mm in diameter and spaced 86 mm apart.
Use two bolts and nuts with a maximum of 8 mm in diameter to fasten
the sand filter to the pedestal.
LOAD POOL-GRADE FILTER SAND/FLOWCLEAR™ POLYSPHERE.
NOTE:
Use only special pool-grade filter sand, free of all limestone
or clay: #20 Silica sand 0.45-0.85 mm, approximately one 20 kg bag
should suffice. If you do not use the recommended size of filter sand,
filtering performance will be reduced and the sand filter may damaged,
thereby voiding the warranty.

IMPORTANT:

sand filter. It is specially graded to trap particles in the 20 - 100 micron range.
Some small debris can pass throw the sand and back into the pool. This is
normal, especially if the debris is fine or silt.
To limit this, it is better to follow the maintenance instructions, and
backwash and rinse when necessary.
We also suggest contacting your pool dealer for the chemical product
specifically made to clean the sand. The correct maintenance of the sand
will optimize the cleaning efficiency and avoid accumulation of oils or scale.
When you are vacuuming the bottom of the pool that has a large amount
of debris, we suggest to backwash the sand when you finish cleaning half
of the pool.
Remember to backwash and rinse the sand after vacuuming the bottom of
the pool each time.
NOTE:
To avoid damaging the Skimmer when adding sand, pour
some water into the Bottom Tank to submerse the Skimmer on the Hub.
NOTE:
Sand/Flowclear™ Polysphere not included.
NOTE:
Use 28 g (0.06 lbs) Flowclear™ Polysphere to replace
1 kg (2.20 lbs) sand.
(You will need a screwdriver.)
We suggest using #20 silica sand with your pool
8
86 mm
Ф8 mm