Oster Cordless Fast Feed Manual De Instrucciones página 3

b. Unplug charger before plugging or unplugging
appliance.
15. The appliance is only to be used with the power supply
unit (Model No. PYS-050H200X001) provided.
16. This appliance contains batteries that are non-replaceable.
17. WARNING: For the purposes of recharging the battery,
only use the detachable supply unit provided with this
appliance.
18. Animal clipper and hair clipper can be used by children
aged from 3 years under supervision.
19. Animal clipper and hair clipper can be used by children
aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given
supervision or instruction concerning use of the appliance
in a safe way and understand the hazards involved.
20. Children should not play with the appliance.
21. Cleaning and user maintenance should not be done by
children without supervision.
22. WARNING: For the purposes of recharging the battery,
only use the detachable supply unit provided with this
appliance.
SAVE THESE INSTRUCTIONS
FOR ANIMAL CLIPPERS ONLY:
The appliance is for trimming purposes only. Animal shearers can only be use by trained personnel.
4
English
DO NOT USE THIS APPLIANCE UNTIL YOU HAVE READ THESE OPERATING INSTRUCTIONS
OPERATE ON VOLTAGE SPECIFIED ON APPLIANCE
HOW TO CHARGE THE UNIT
Place clipper on charging stand or connect directly to the power supply cord. This clipper has one control LED
INDICATOR.
Trimmer Off Charger
Battery Level <20% Solid Red
Battery Level <10% Pulsing Red
Faulty Battery Quick Pulsing Red
Trimmer In Charger
Charging Pulsing Green
Fully Charged Solid Green
CHARGING WITH THE CHARGING STAND
1. Plug the power cord of the charging stand into an outlet with the rate voltage for your unit.
2. Plug the other end into the charging stand. Note that the cord will only fit into the charging stand
with the proper orientation.
3. Ensure that the switch on the unit is in the «OFF» (O) position.
4. Check the contacts of the trimmer and the battery for foreign particles and contamination.
5. Insert the trimmer into the charging stand so that the top of unit is facing you and the contacts
on the trimmer are aligned with the contacts on the charging stand. The top of the unit is the side
with the switch (Figure 1).
6. While the unit is being charged, the LED will pulse green until fully charged. Once the battery is
fully charged, the LED will display a continuous green light and is ready for use.
7. If the LED light will not turn on, then re-insert the trimmer into the charging stand and push down
gently on the trimmer to engage the contacts. Note: If the LED does not turn on then there may be dirt or grease
on the contacts of the charging stand or trimmer. Clean the contacts with an approved cleaning solution and re-
insert the trimmer into the charging stand. If the LED still fails to turn on then follow the return procedure under
the warranty and service section.
8. The LEDs will stay on as long as the unit is in the charging stand.
ABOUT THE CLIPPER
5
English
Figure 1