Battery Information - Battery Watering Technologies Direct Fill Link+ Manual De Instrucciones

The flow meter is shipped with (2) alkaline AAA size batteries (1.5-volts each) and
(1) lithium CR2477 (3 volts) installed.
RECOMMENDED BATTERY REPLACEMENTS
Alkaline (AAA size, 1.5-volts each)
Energizer, Alkaline, E92 or En92
Duracell, Alkaline, Mn2400
NOTE: It is recommended to replace the batteries every year.
If the flow meter's readout should become dim, blank or the low battery message
appears (see below), the AAA batteries should be replaced.
NOTE: When batteries are disconnected or fail, the flow meter memory will retain
the batch total, accumulative total, factory calibration curve, and field calibration
curve indefinitely.
The CR2477 lithium battery level is displayed in FRED. See the "FRED Integration"
section of this manual for more information.
STORING WHEN NOT IN USE
Removing the batteries before storing the flow meter will extend battery life
since the flow meter is always on (either standby or active) when the batteries are
installed.

BATTERY INFORMATION

Do not mix brands or technologies.
Do not mix old and new batteries.
Do not use rechargeable batteries.
Lithium CR2477 size (3-volts)
Panasonic, Sony or Toshiba
If the AAA battery life is sufficiently
low, "LOWBAT" will be displayed in the
message area on the bottom row of
characters. This low battery message
will be displayed automatically without
running a diagnostic battery check.
8