brondell Swash T22 Manual Del Propietário página 13

5. Installing mounting plate
a. Wet the rubber anchors with water,
squeeze the sides of the anchors, and
firmly press them all the way down into
the mounting holes on top of the toilet.
TIP: Wetting the rubber anchors will
allow for easier installation. The top of
the anchors should be flat to the surface.
Step 5a
b. Place the mounting plate over the rubber
anchors on the toilet.
c. Place the adjustable brackets flat side
down on the mounting plate over the
rubber anchors.
d. Insert the metal mounting bolts through
the adjustable brackets and rubber
anchors; use a Phillips screwdriver to
screw in the mounting bolts and tighten.
Steps 5b–5d
6. Insert the deodorizer cartridge into the back
of the bidet body and attach the deodorizer
cover until it snaps into place.
Step 6
7. Connect the bidet hose to the seat
Connect the bidet hose to the water inlet
and hand-tighten to secure; take care not
to twist the bidet hose, excessively bend
it, or strip the plastic screw threads when
screwing the hose onto the bidet seat.
Step 7
8. Attach the bidet seat to the mounting plate
a. Set the bidet seat flat on the toilet bowl
in front of the mounting plate. Slide seat
forward onto plate until it clicks into place
and is secure.
b. If the seat does not align with the front
edge of the toilet bowl, remove the seat
by pressing the quick-release button
located on the right side of the seat and
slide it off the mounting plate.
Continued following page
13