Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 2
9
12
Figure 3
Figure 4
PAGE 2 OF 9
ASSEMBLY INSTRUCTIONS CONTINUED
8
10
11
2. Align armrest with arm holes on underside of seat
cushion and insert two 1/4 x 1¾" screws (9) and one
1/4 x 1½" screw (8) to attach. Use washers (12) with all
screws and fully tighten using Allen wrench. Repeat
on opposite side. (See Figure 2)
3. Align mechanism over pre-drilled holes on underside
of seat cushion. Attach mechanism to seat cushion
using four 5/16 x 1" screws (10). (See Figure 3)
4. Align back cushion with seat cushion by positioning
back support plate over mechanism. Insert four
5/16 x 1½" screws (11) to attach back support to seat.
(See Figure 4)
Note: Two front holes will attach to mechanism
and seat cushion, while two back holes will
only attach to the seat.
0221 IH-7589
Publicidad
