Scott Living HDSLFP65W-4A Instrucciones De Montaje página 17

Assembly (continued)
25
Interchanging door insert panels
□
To change door panels, loosen the screws on the inside of the door and rotate the clips to remove the panel.
Replace with the desired panel, then rotate clips to secure the panel within the door frame and tighten screws.
NOTE: The glass door panels are pre-attached when shipping. You can keep as is or interchange as the desired
configuration.
26
Installing the tipping restraint hardware
WARNING: Young children can be seriously injured by tipping furniture. You must install the tipping restraint hardware
with the unit to prevent the unit from tipping, causing any accidents or damage. The tipping restraints are intended only
as a deterrent, they are not a substitute for proper adult supervision. The tipping restraints are not earthquake restraints. If
you wish to add the extra security of earthquake restraints, they must be purchased and installed separately.
□
With assistance, position the assembled fireplace at the desired location against a wall. If necessary, adjust the
pre-attached floor levelers by hand to correct tilting and level the doors, until the unit is level.
□
Follow the instructions printed on the plastic bag containing the tipping restraint hardware to attach the tip-over
restraints to the unit and the wall.
□
Connect the fireplace to the power transformer. Follow the operating manual for the electric fireplace insert to control
your fireplace.
Wall
Metal bracket
Nylon strap
Short screw
Long screw
The moldings face outward
Wooden stud
Wall
S/T
U
Glass door panel Wood door panel
Floor leveler