Environmental Protection; Technical Specifications - Metabo HS 18 LTX BL 55 Manual Original

12. Repairs
Repairs to electrical machines must ONLY be
carried out by qualified electricians!
Contact your local Metabo representative if you
have Metabo machines requiring repairs. For
addresses see www.metabo.com.
You can download a list of spare parts from
www.metabo.com.

13. Environmental Protection

Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Packaging materials must be disposed of according
to their labelling in accordance with municipal
guidelines. Further information can be found at
www.metabo.com in the "Service" section.
Battery packs must not be disposed of with regular
waste! Please return faulty or used battery packs to
your Metabo dealer!
Do not throw battery packs into water.
Only for EU countries: never dispose of
machines in your household waste!
According to European Directive 2012/19/EU
on Waste from Electric and Electronic Equipment
and implementation in national law, used machines
must be collected separately and recycled in an
environmentally-friendly manner.
Discharge the battery pack in the machine before
disposal. Prevent the contacts from short-circuiting
(e.g. by protecting them with adhesive tape).

14. Technical Specifications

Explanatory notes on the specifications on page 3.
Subject to change in accordance with technical
progress.
U = Voltage of battery pack
ø max. = maximum cutting thickness
L = Useful blade length
n = number of cuts at idling speed
0
m = Weight with smallest battery pack
Measured values determined in conformity with EN
62841.
Permitted ambient temperature during operation:
-20 °C to 50 °C (limited performance with
temperatures below 0 °C). Permitted ambient
temperature for storage: 0 °C to 30 °C
direct current
The technical specifications quoted are subject to
tolerances (in compliance with relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the machine and to compare
different machines. The actual load may be higher
or lower depending on operating conditions, the
condition of the machine or the accessories used.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Vibration total value (vector sum of three directions)
determined in accordance with EN 62841:
a = Vibration emission value (idle speed)
h
K = Uncertainty (vibration)
h
Typical A-effective perceived sound levels:
L = sound-pressure level
pA
L = Acoustic power level
WA
K , K = Uncertainty
pA WA
L = guaranteed acoustic power level as per
WA(G)
2000/14/EC
During operation the noise level can exceed
80 dB(A).
Wear ear protectors!
ENGLISH en
11