Fellow ODE Información De Seguridad Y Mantenimiento página 8

Diagram D
Take care not to lose any pieces as you remove. See Diagrams
D & E for reference. If you are just cleaning, do not disassemble
the burrs further. Using the provided brush, gently brush coffee
dust off of the burrs and replace burrs.
If you are replacing the burrs, continue onto the next steps.
6. The stationary burr is attached to the grinds chamber. To remove
the stationary burr, start by using a Phillips-head screwdriver to
remove the three screws that hold it in place. If there is ground
coffee in these screws that interferes with their removal, use a small
brush to clear the ground coffee before attempting to remove the
screws. Carefully remove the stationary burr (Diagram F) .
7. The rotational burr is attached to the auger. To remove the
rotational burr, start by using a Phillips-head screwdriver to
remove the three screws that hold it in place. If there is ground
coffee in these screws that interferes with their removal, use
a small brush to clear the ground coffee before attempting to
remove the screws (Diagrams G & H) .
14
Diagram E
Spring
Rotational Burr
and Auger
Auger Key
Diagram F
1/3
Diagram G
8. Carefully lift the rotational burr away from the auger.
To replace the burrs, repeat these steps in reverse order. Make
sure that the rotational burr is reattached to the auger and that
the stationary burr is reattached to the grinds chamber.
2/3
3/3
Diagram H
15