Electrical Connection; Wiring Diagram; Glass Cover Replacement; Leak Check - Furrion FGRG3A1 Serie Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Electrical Connection

CAUTION
PRODUCT DAMAGE HAZARD
● Connect to 12V DC service only.
● Connect only to protected circuit fused for not more
than 15 Amps.
● DO NOT hi-pot range unless electronic ignition system
has been disconnected.
Connect a positive 12V power supply wire to the range oven
red 12V light wire and a negative 12V power supply wire to the
range oven black 12V light wire. (Fig. 8)
NOTE: Ensure to connect the wires with the correct polarity.
Red is "+" and Black is "-".
Fig. 8

Wiring Diagram

Knob lights
-
+
BATT
0
=
Oven lights
Oven Cavity Lamp
10W/G4/300°C
Position
switch
Ignitor Knob PCB
Cooktop rear left
Knob PCB
BATT

Glass Cover Replacement

1. Align the top glass cover assembly tabs x 2 with the slots
on the back side of the console and place it into the top of
the range cooktop. (Fig. 9)
Fig. 9
CCD-0005503 Rev: 05-06-22
Position
Position
Position
switch
switch
switch
Cooktop front Knob
Cooktop rear right
Oven Knob PCB
PCB
Knob PCB
2. Press the backside of the top glass cover and you will
hear a click noise. The top glass cover is now locked into
place. (Fig. 10 and Fig. 11)
Fig. 10
Fig. 11

Leak Check

Leak testing of the appliance shall be conducted according
to the manufacturer's instructions.
FIRE OR EXPLOSION
● Extinguish all open flames.
● NEVER leak test when smoking. Never use a flame.
● Do not use the appliance until connection has been leak
tested and does not leak.
● Pressure/Leak test using 11-13.8 WC pressure.
● Gas leaks may occur in your system and result in
a dangerous situation. Always perform a leak test
for possible leaks according to the manufacturer's
instructions after installation and before any operation.
● Gas leaks may not be detected by smell alone. Gas
suppliers recommend you purchase and install a UL
approved gas detector.
1. Make sure all control knobs are in the OFF position.
2. Apply a gas leak detection liquid to the connections.
gas leaks will be indicated by bubbles.
3. If a gas leak is detected, tighten the loose joint, or replace
the faulty part with a replacement part recommended by
Furrion authorized retailer.
- 9 -
WARNING
WARNING
Any

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Fgrg3a2 serie

Tabla de contenido