Intended Use; Identification Plate; Operating Elements; Operation - Wolf Garten BS 140 eM Instrucciones De Funcionamiento Originales

Safety information
¾ Do not store the operating arm / power pack
in locations in which the temperature may
exceed 40°C .
¾ Observe all instructions and information
contained in the power tool operation
manuals concerning how the operating arm
can be mounted .
¾ Observe all instructions and information
contained in the instruction manual of the
charger, which is provided for charging the
power pack unit in the operating arm .

Intended use

The operating arm with the permanently installed
power pack / power pack unit is only intended for
use in electrical power tools/accessories approved
by the manufacturer.
The power pack / power pack unit must only be
charged using the charger approved by the manu-
facturer. Information concerning regarding approved
chargers, electrical power tools and accessories can
be obtained from your salesman or directly from the
manufacturer.
Identification plate
Position
The identification plate is located on the operating
arm.
Note
The identification is considered as a docu-
ment. It must never be altered or obliterated.
Layout E
1 Manufacturer
2 Model name
3 Model number
4 Serial number
5 Device group
6 Rated voltage / type of current / capacity / energy
7 Maximum charging voltage
8 Maximum charging current
9 Cell type
10 Lithium-ion power pack
11 Recycling symbol
12 CE mark
13 Disposal instruction
14 Year of manufacture
Safety information
¾ If the charger or mains cable is damaged,
pull out the mains plug immediately . Repairs
may only be performed by an authorised
specialist dealer . Improper repairs can result
in significant danger for the user.
Operating elements A
1 Lock-on switch
2 On/off switch on handle
3 Handle
4 Holding area for the hand / fastening area for the optional
middle handle
5 Middle handle*
6 Locking button
7 Contact plug of the power pack unit permanently installed in
the arm
*optional accessories
Risk of injuries or material damage.
¾ Only charge the power pack using the
The power pack is supplied partially charged.
Before first use, fully charge the power pack to
ensure full capacity of the power pack.
Note
The power pack becomes hot during oper-
ation.
Charge discharged power packs within
a week, because their service life is sig-
nificantly reduced if they are stored in a
discharged state.
Note
The lithium-ion power pack can be charged
in any charge status and charging can be
interrupted at any time without damaging the
power pack.

Operating elements

Operation

WARNING!
charger approved by the manufacturer.
Note
EN
15