Transport And Storage - Wolf Garten BS 140 eM Instrucciones De Funcionamiento Originales

EN
General information about the power pack
The Li-ion power pack is protected against deep
discharge and overheating while in use. If the power
pack is discharged and the power pack temperature
is greater than 70 °C, the electrical power tool is pro-
tected by a protective circuit so that the tool being
used no longer moves.
If the power pack is overheated, allow it to cool.
Î
Mounting / adjusting the middle handle A B
(optional accessories)
Note
The middle handle is available as an option-
al accessory for the operating arm. It is used
to easily hold the operating arm during work
/ use with a wide variety of power tools, such
as a trimmer unit, hedge trimmer unit, etc.
Open the quick release attachment on the middle
Î
handle B 1 .
Place the middle handle on the encased area A
Î
[4] of the operating arm at the desired position
B 2 .
Note
The middle handle must only be mounted
on the encased area of the operating arm
since this area is simultaneously used as an
adjustment limitation for the middle handle.
Slide the middle handle to the desired height and
Î
adjust the inclination (depending on the design)
B 3 4 .
Attach the middle handle by closing the quick-re-
Î
lease lever B 5 .
Connect the operating arm with the power
tool C
Press the locking button [A] on the operating arm
Î
and insert the operating arm into the receptacle
on the power tool until the locating button [B]
engages into the receptacle 1 2 .
Attention!
Ensure that it is engaged properly.
Remove the operating arm on the power
tool D
Attention!
Switch off the power tool before removing the
operating arm and wait for all moving parts of the
power tool to come to a standstill.
Press the locking button [A] on the operating
Î
arm 1 .
16
Pull the operating arm fully out of the receptacle of
Î
the power tool unit [B] 2 .
Note
Observe all instructions and information from
the instruction manual of the expandable
power tools as well as of the charger.

Transport and storage

Transport
Secure the device sufficiently to prevent its unin-
Î
tentional slipping if you are transporting it on or in
a motor vehicle.
Note
Li-ion power packs are subject to the re-
quirements of the dangerous goods act. The
user can transport the power packs by road
without additional documentation. If sending
via a third party (e.g. airfreight or freight for-
warding) special requirements in respect of
packaging and labelling must be observed.
In this case, refer to a hazardous goods
expert for preparation of the package.
Only send the operating arm with the permanently
Î
installed power pack / power pack unit if the oper-
ating arm is undamaged.
- Apply insulating tape to open contacts.
- Pack the operating arm with the permanently in-
stalled power pack / power pack unit so that it can-
not move within the package.
It may be necessary to adhere to other related
Î
national regulations.
Storage
Clean your device thoroughly at the end of every
Î
season.
Always store the device in a dry and safe location
Î
that is inaccessible to children.
Store the operating arm with the permanently
Î
installed power pack in a cool and dry location.
Recommended storage temperature approx. 0 -
23°C.
Keep the operating arm and especially its plastic
Î
components away from brake fluids, petrol,
mineral oil containing products, penetrating oils
etc. They contain chemical substances that can
damage, attack or destroy the plastic components
of the operating arm.
Fertilizers and other garden chemicals contain
substances that may have a highly corrosive effect
on the metal parts of the operating arm. There-
fore, do not store your operating arm in the vicinity
of these substances.
Charge the power pack before storage.
Î
Charge the power pack after a long period of
Î
non-use.
Transport and storage