RugDoctor TDC-1 Manual Del Usuario página 13

How to Use:
upholstery tool (CONT)
6
Plug in the Machine
Insert plug into a
properly grounded
outlet.
CAUTION
Before plugging
machine in, check
the Power Button
to make sure it
is in the "off"
position.
8
Connect Solution Hose
Connect the SOLUTION
HOSE to the "TOOL CLEAN
PORT B" located on the top
of the machine by lining up
the "O" icons on the hose.
Lock the hose into place by
rotating to the right. The
icon will be straight up.
10
Clean Your Upholstery, Stairs, Stains
To Clean: Position the UPHOLSTERY TOOL in front of the area or
stain you want to deep clean. Squeeze trigger on the handle to begin
cleaning. While squeezing the trigger, move the tool back and forth
over the area you want to clean, making sure to press the suction nozzle
down into the surface.
To Dry: Release the trigger. Move the tool back over the wet area.
Make sure to press the suction nozzle down into the surface.
Leave the machine on for 15 seconds after cleaning to allow for all of
the dirty solution to be collected into the DIRTY WATER TANK.
r u g d o c t o r . c o m | 1 - 8 0 0 - 7 8 4 - 3 6 2 8
IMPORTANT: Check the manufacturer's tag
before cleaning upholstery. "W" or "WS" on
the tag means you can use Machine. If tag
is coded with an "S" or "X", says "Dry Clean
Only", is coded with any non-color-fast fabric,
is missing, or not coded, do not proceed.
7
Insert Upholstery Tool
1. Open the UPHOLSTERY TOOL A
by pulling on the black rubber flap.
2. Insert the UPHOLSTERY TOOL
connection into the UPHOLSTERY
TOOL A on the front of the DIRTY
WATER TANK by lining up the
"O" icons on the tank and the
UPHOLSTERY TOOL.
3. Lock the TOOL into place by
rotating to the right, the icon will
be straight up.
9
Turn on the Machine
Press the POWER BUTTON
located on the COMFORT
GRIP HANDLE to Tool
position.
Squeeze trigger
pull back
tool
13