Pole Assembly - sunjoe 24V-CTC-CT Manual Del Operador

2. To attach a brush, first insert the tightening rod through the
hole in the spindle to lock it in place (Fig. 5).
Fig. 5
Spindle
Tightening rod
3. Insert the small washer over the spindle. Then place either
the nylon or wire brush followed by the big washer over
the spindle as well. Using the wing nut, tighten counter-
clockwise by hand until the components are secured. Once
tightened, remove the tightening rod to allow the spindle to
rotate freely (Fig. 6).
Fig. 6
Small
Spindle
washer

Pole Assembly

1. With the cam lock open, insert the end of the sweeper head
into the bottom of the pole assembly. They should snap
together with an audible "click" (Fig. 7).
Fig. 7
Cam lock
Sweeper head
Big
Washer
Wing nut
Brush
Pole assembly
8
2. Close the cam lock to secure the sweeper head in place
(Fig. 8).
Fig. 8
Cam lock
3. To adjust the length of the pole, loosen the locking collar
by turning clockwise. Then extend the pole to your desired
length (Fig. 9).
Fig. 9
Locking collar
4. To secure the pole in place, twist the locking collar counter-
clockwise until it is tight.
5. Attach the auxiliary handle onto its mounting point on the
pole using the included bolt and handle knob (Fig. 10).
Fig. 10
Bolt
Handle knob
Auxiliary handle