Craftsman 580.988390 Instrucciones De Uso página 18

ProbJern
Pump has following problems:failure
to producepressure, erratic pressure,
chattering, loss of pressure, low water
voJurne.
Unit fails to start when spray gun
trigger is squeezed.
Detergent faiJsto mix with spray.
Cause
1. Water inlet is blocked.
2. inadequatewater supply.
3. Garden hose is kinked or leaking.
4. Cloggedwater inlet screen.
5. Water supply is over IO0°F (38°C).
6. High pressure hose is blocked or
leaks.
7. Nozzleis obstructed.
8. Pump is faulty.
1. Water supply is not turned on.
2. Unit is not turned on.
3. Garden hose is too long.
1. Siphon tube is clogged or cracked.
2. Siphon tube is loose or
disconnected from tube connection
of foam lance.
3. Wand adjustment setting is
incorrect.
Correction
1. Clear inlet.
2. Provide adequatewater flow.
3. Straighten garden hose or replace if
leaking.
4. Checkand clean water inlet screen.
5. Provide cooler water supply.
6. Clear blocks in high pressure hose
or replace hose.
7. CleanNozzle.
8. Contact Sears service facility.
1. Turn on water supply.
2. Press the master ON/OFF switch to
the Pressure WasherON position
(I). Reset GFCI.
3. Use only 50 ft. (15.24 m) maximum
garden hose.
1. Cleanor replacesiphon tube.
2. Connect siphon tube securely onto
tube connection of foam lance.
3. Adjust wand setting as instructed in
Applying Detergent.
18