EINHELL TP-RO 18 Li BL Manual De Instrucciones página 24

in place.
•
Perform the cut as described in section 6.4.
6.7 Making cuts with the parallel stop (27)
Proceed as follows to cut along a straight outer
edge of a workpiece:
•
Fit the parallel stop (27) as explained in sec-
tion 5.3.
•
Move the parallel stop (27) along the outer
edge of the workpiece.
•
Perform the cut as explained in section 6.4.
6.8 Making cuts freehand
The cordless router can also be used without any
guides. You can use it freehand on creative jobs
such as the production of lettering.
•
Use a very flat cutter setting for this purpose!
•
Check the direction in which the cutter is tur-
ning while you machine the workpiece (Fig.
13).
6.9 Cutting shapes and edges (Fig. 14)
•
Special cutters with a guide ring can be used
for cutting shapes (a) and edges (b).
•
Fit the cutter.
•
Carefully move the machine against the work-
piece.
•
Using gentle pressure, move the guide jour-
nal or ball bearing (c) along the workpiece.
Warning:
For deep cuts, carry out the work in several
steps according to the material in question.
Hold the equipment in two hands during all
cutting work.
6.10 Charging the LI battery pack (Fig. 15-16)
1. Remove the battery pack (k) from the handle,
pressing the pushlock buttons (l) downwards
to do so.
2. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Insert the power plug of the charger
(6) into the mains socket outlet. The green
LED will then begin to fl ash.
3. Push the battery pack onto the battery char-
ger.
In section "Charger indicator" you will fi nd a table
with an explanation of the LED indicator on the
charger.
If the battery pack fails to become charged, ple-
ase check
•
whether there is voltage at the socket-outlet
•
whether there is proper contact at the char-
Anl_TP-RO_18_Li_BL-Solo_SPK13.indb 24
GB
ging contacts on the charger.
If the battery still fails to become charged, please
return
•
the charger
•
the battery pack
to our Customer Service Department.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
6.11 Battery capacity indicator
(Fig. 17/Item n)
Press the battery capacity indicator switch (o).
The battery capacity indicator (n) shows the char-
ge status of the battery using 3 LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
- 24 -
11.07.2022 08:42:31