Aqara Smart Pet Feeder C1 Manual Del Usuario página 6

Note: please do not rinse the lower part of the device to avoid any
device failure.
Button Operations
Operation
Feed once
Voice recording
Check the
binding state
The device is
restored to
factory settings &
configures
network
Click the feed button, and the feeder will give
a portion of food once. The number of
portions can be set in the app.
Note: one portion weighs about 6-10g, which
varies with the size of the food particles.
Please set the number of portions for every
feeding according to your pets' habits and the
actual weight of one portion.
Press and hold the voice record button, and
recording will start a er a "beep" sound. Press
and hold the button until you finish the
recording, and then you will hear "beep,
beep" to mark the completion of recording.
Click the reset button. If the indicator light
flashes in blue three times, the device is
connected to the network.
If the indicator light turns red for about 1
second, the device is not connected to the
network.
Press and hold the reset button for 5 seconds
until the indicator light turns blue and flashes
continuously:
the device is restored to factory settings and
is configuring network.
The configuration status will last for 30
seconds, and in this period:
a. If the user completes network configura-
tion for the device successfully via the Aqara
Home app, the indicator will stop flashing.
b. If the configuration fails, the red indicator
will flash shortly and then stop.
c. If there are no other operations, the
indicator will be o
network access will end.
-4-
Steps
a er 30 seconds and