Ashdown Engineering MF 484 2.N Manual De Instrucciones página 4

MF 484 2.N
22.
10. 11.
11. MAINS
Power on and off with the switch provided once connected to the mains input.
12. TORPEDO OUT
This is a balanced XLR DI output derived from the DynIR output.
13. HEADPHONES
There is a 32 Ohm headphone out for use in silent practice.
14. FS-1 FOOTSWITCH INPUT
Input to connect an FS-1 footswitch (sold seperately), use to turn boost on & off.
USER GUIDE
21.
USB
12. 14. 15. 16. 17. 18.
13.
MF 484 2.N
15/16. SPEAKER OUTPUTS
Two speaker output sockets are provided at an impedance of 8 or 16 ohms
only ONE must be used at any one time, the socket being chosen to match the
impedance of the cabinet combination in use at the time.
The on-board reactive load enables the amplifier to function without a load
connected.
20.
17. TORPEDO LINE IN & DI LINK
19
The TORPEDO LINE IN & DI LINK is an option that enables you the possibility of
using the MF 484 2.N as a re-amping unit to run your pre recorded lines giving them
some alternative tonal options with a number of alternative
settings available via the embedded Two notes Torpedo.
The DI LINK push button links/unlinks the DIRECT DI
and DynIR to isolate the signal.
18. DIRECT DI
This is transformer derived from the output and as such will have all the adjustments
made with the tone controls, all effects in use and some influence from the speaker
in use. The level obtained is dependent on playing volume. But as a general rule is
suitable for line level (0,775V).
19. GROUND LIFT
A ground lift is fitted.
20. MIDI IN/OUT
Midi IN and OUT sockets are provided to enable control via a midi controller
(available seperatly) over the available functions via the Two notes Torpedo. (See
MIDI for more info).
21. USB - PROGRAM/CHARGE
To either program the on-board Two notes Torpedo embedded firmware or with the
handy option to keep your USB device charged...
USER GUIDE