Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. Operating the Appliance
•
When operating this appliance, please take care to ensure that all parts are in good working order and that you have checked for any gas
leaks before lighting the appliance with every use.
•
Cooking surfaces can simply be placed and are ready to use. No assembly required.
•
PLEASE NOTE: Please ensure all protective packaging and plastic are removed from the appliance before use.
•
The appliance is designed for use with cooking vessels of not less than 7" in diameter and not greater than 10" in diameter.
Precautions to observe before lighting.
•
Use this appliance only on a firm level surface.
•
After prolonged storage, inspect the appliance for any insects and webs, which may affect gas flow.
Lighting the appliance using the piezo
•
It is recommended to remove any cooking surfaces when trying to light the appliance. This way it will be easy to see the burner when it is lit.
• To light up the appliance using the piezo igniter, push and turn the control knob in an anticlockwise direction until you hear a click. If the gas
does not ignite on the first spark, turn the control knob back to its "OFF" position. Try again, by pushing and turning the control knob
anti-clockwise until you hear a click. If the gas has not ignited in the first two to three seconds you should close the control valve by turing
the control knob back to its "OFF" position.
• Wait approximately thirty seconds to let any accumulated gas within the burner escape. Repeat the above process if necessary until the
flame ignites. The flame should normally light up within the first one to two seconds.
Lighting up using a BBQ lighter
•
When starting cold, the appliance may be lit from the top prior to fitting the desired cooking surface onto the fat pan. When lighting up a
hot appliance, it is recommended that this be done by sticking a barbecue lighter through one of the vent holes underneath the burner,
until it is in line with the burner (DO NOT place the BBQ lighter through the large hole directly underneath the burner). Ignite the BBQ
lighter. Whilst the BBQ lighter is lit, push and turn the control knob anti-clockwise to light the burner.
General
•
Use the control knob to adjust the flame intensity to the desired level by turning the knob clockwise to decrease the flame and anti-
clockwise to increase the flame.
•
When cooking food with a high fat content, flaring may occur if the selected heat setting is too high. Should this happen, turn the heat down
until the flaring ceases.
•
Do not move the appliance when in use. It is unsafe practice to move the appliance whilst lit and may cause flaring.
•
When not in use remove the gas cartridge
Fig. 3a
Seal
Notch
Fig. 3c
3 3
Fig. 3b
Fig. 3d
Safety Guide
EN
Publicidad
Tabla de contenido
