Humanscale M Connect 2 Guía De Montaje página 16

Replacing the M/Connect Hub (If Applicable)
In the event of damage/failure of the M/Connect Hub
1
Using the guide below, determine if your M/Connect Hub is removable.
Disconnect the bridge cable from the M/Connect Dock. ③
2
Disconnect the power and upstream cables from the M/Connect Hub. ④
3
4
Remove the two security screws from the rear side of the unit using a 2mm
hex key. ⑤
Slide the M/Connect Hub towards the front of the desk and lift to remove. ⑥
5
6
Install the replacement hub and fasten with the two security screws.
7
Reconnect all cables.
NOTICE: Removable hub must be fully installed prior to turning on the unit.
HOW TO DETERMINE
M/CONNECT VERSION
Previous Version (Not removable)
Top cover is one continuous piece
New Version (Removable)
Top cover has "U"-shaped split line
16
①
②
③
④
⑤
⑥