Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
DC to DC Battery Charger
Thank you for purchasing the DC to DC Battery Charger
normal care and proper treatment, it will provide years of reliable service. Please
read all operating instructions carefully before use.
The 25A and 40A DC to DC Battery Chargers are designed to provide the
optimal charging characteristics for your auxiliary battery from either your
alternator or external solar source. The solar controller is designed with
Maximum Power Point Tracking (MPPT) to maximize the power coming from your
solar panels up to the maximum rated output. The DC to DC chargers also allow
you to select either vehicle power or solar power priority and is programmable
for all common types of automotive lead acid batteries and LiFePO
batteries.
CAUTION
•
Do not charge a LiFePO
•
Do not operate the battery charger unless you have read and understood
this manual and the charger is installed as per these installation instructions.
We recommend that the charger be installed by a qualified person.
•
The battery charger should not be used by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they are supervised or have been instructed on how to
use the appliance by a person responsible for their safety.
•
Do not alter or disassemble the Battery Charger under any circumstances.
•
Only use the battery charger for charging 12V standard automotive lead
acid, Gel, AGM, Calcium or LiFePO
•
Check the manufacturer's data for your battery to ensure that the maximum
voltage of the profile you select as shown in the "Charge Control" section
of this manual does not exceed the manufacturer's recommended max
charging voltage. If the max voltage is too high for your battery type,
please select another charging profile.
1
by Wagan Tech
™
battery when temperature is below 32ºF (0ºC).
4
type batteries.
4
www.wagan.com
®
by Wagan Tech
™
type starting
4
. With
®
Publicidad
Tabla de contenido
