Installation; What's In The Box; Before Installation; Microwave Oven Installation - Furrion FMAN09-BL Manual Del Usuario

Installation

What's in the Box

Make sure all the following items are included in the
packaging. If any item is damaged or missing, contact your
dealer.
● Microwave Oven Body x 1
● Roller Ring x 1
● Glass Tray x 1
● Bake Plate x 1
● Air Fry Kit
● User Manual
● Warranty Manual
NOTE: Trim Kit Sold Separately
● One-Piece Trim Kit:
- FMSML09-BL-TK
- FMSML09-SS-TK
● Standard Trim Kit:
- FMSM09-BL-TK
- FMSM09-SS-TK

Before Installation

1. Make sure that all the packing materials are removed from
the oven cavity.
2. Check the oven for any damage, such as misaligned
or bent door, damaged door seals and sealing surface,
broken or loose door hinges and latches and dents inside
the cavity or on the door. If there is any damage, do not
operate the oven and contact qualified service personnel.
3. This microwave oven must be placed on a flat, stable
surface to hold its weight and the heaviest food likely to
be cooked in the oven.
4. Do not place the oven where heat, moisture, or high
humidity are generated, or near combustible materials.
5. The oven must have sufficient airflow. Do not cover or
block any openings on the oven. Do not remove feet on
which oven stands.
6. Do not operate the oven without glass tray, roller support,
and shaft in their proper positions.
7. Make sure that the power supply cord is good in condition
and does not run under the oven or over any hot or sharp
surface.
8. The electrical outlet or circuit breaker must be accessible
to disconnect power in an emergency.

Microwave Oven Installation

WARNING
This microwave is designed to only be installed above the
countertop. (Minimum 3 feet (91.44cm) above the floor)

Cabinet Preparation

1. Select a suitable place that is not susceptible to moisture.
2. Mark and cutout an opening in the cabinet according to
the dimensions outlined in the table.
NOTE: If a range hood is installed under the microwave
oven, 1 inch minimum clearance must be reserved from
CCD-0006038 Rev: 09-21-22
the bottom of the microwave oven to the top of the range
hood refer to dimension E.
A
1915/16"
133/8" (339.7mm)
(506.4mm)
Min. to 137/8"
Min. to 201/4"
(352.4mm) Max.
(514.3mm) Max.
Trim Kit Installation (Sold Separately)
Two trim kit types are available:
● One-Piece Trim Kit: FMSML09-SS-TK, FMSML09-BL-TK
● Standard Trim Kit: FMSM09-SS-TK, FMSM09-BL-TK.
One-Piece Trim Kit Installation
1. Take out the microwave oven and the component(s) from
box and put on a flat surface.
2. Attach the trim kit onto the oven. (Fig. 1)
Fig. 1
3. Attach the trim kit onto the microwave oven with 4pcs
M4 x 5/16" screws. (Fig. 2)
- 5 -
Dimensions
B C D
161/8" 1/2" (12.7mm)
(410mm) Min. Min.
M4 x ⁄ "
screw x 4
Trim Kit x 1 M4 x 5/8"
screw x 4
E
1"
(25.4mm)
Min.