Section Vi. General Descriptions And Information Of Parts - iM3 ART-SP6 Instrucciones De Uso

SECTION VI：GENERAL DESCRIPTION AND INFORMATION OF PARTS
1. Main unit
2. Hand piece
3. Mode / Power control knob
4. Micro-motor socket
1. Main Unit
The main unit generates power and produces a signal that is passed to the hand piece. The
hand piece is then powered up and vibrates the installed tip.
2. Hand piece
The hand piece is the housing for the piezo tip. It consists of four piezoelectric plates that
vibrate. The plates are driven by the electrical signal from the Main unit. The ART-SP6 unit
is compatible with Bonart BS-type piezo tips and other brands of piezo tips with a comparable
thread. Do not use Bonart BE-type piezo tips with the ART-SP6.
3. Mode/Power control knob
The Mode/Power Control Knob is use to switch between polishing and scaling mode and
control the power in scaling and/or polishing mode.
Do not press the foot switch while turning on the ART-SP6
4. Micro-motor Socket
The micro-motor socket is where you connect the micro-motor to the main unit. It is located
in the front of the main unit at the bottom left.
5. LCD display
6. Water control knob
7. Water hose input
8. Foot switch socket
Figure 7. ART-SP6 diagram
- 18 -
9. Power cord socket
10. Power button
11. Forward/Reverse switch