poolstar POOLEX MAG Serie Manual De Usuario Y Instalacion página 107

4.8 Status values and advanced settings
WARNING: This operation is used to assist servicing and future repairs.
The default settings should only be modified by an experienced professional person.
The system's settings can be checked and adjusted via the remote control by following these
steps
Step 1 : Keep pressing
Step 2 : Press and
Step 3 : Press to select the setting to be modified.
Step 4 : Press and
Step 5 : Press to set the new value.
Step 6 : Press to return to the main screen.
Parameters Meaning
F1 Heating setting temperature
F2 Cooling setting temperature
F3 Mute Setting temperature
F4 Set temperature in automatic mode
F5 Linkage switch function
F6 Return differential temperature in heating mode
F7 Return differential temperature in cooling mode
F9 Return differential temperature in automatic mode
F10 Upper heating temperature
F11 Lower cooling temperature
F21 Pump interval running time
F22 Ambient temperature for enabling auxiliary electric heating
F23 Temperature compensation value
F40 Coil temperature for starting defrosting
F41 Coil temperature for exiting defrosting
F42 Ambient temperature to allow defrosting
The set difference between the ambient temperature and the coil
F43
temperature for starting defrosting
The over heating temperature of difference between ambient
F44 temperature and coil temperature at which defrosting is started in
advance
F45 Compressor operation cycle of entering the defrosting
F46 Defrosting running time, 0 is to cancel the defrosting function
F51 Main valve regulating cycle
F55 Target superheat when heating
F56 Target superheat when cooling
F57 Minimum opening of main valve when cooling
F58 Minimum opening of main valve when heating
F78 Extended parameter - The serial number of the parameter
F79 Extended parameters - The set data
Reserved, do not modify : F8 F12 F17 F20 F24 F25 F26 F27 F28 F29 F30 F31 F32 F33 F34 F35 F36 F47 F48 F50
F52 F53 F54 F59 F70 F71 F72 F73 F74 F75 F76 F77 F80 F81 :
4. Use
3s until you enter the settings verification mode.
for see the parameters.
to adjust the setting value.
Range Unit Default
20~80 °C 30
5~30 °C 12
20~80 °C 50
10~60 °C 30
0~2 2
0~10 °C 2
0~10 °C 2
0~10 °C 2
20~80 °C 40
5~30 °C 10
0~120 Min 5
-50~30 °C -20
-10~10 °C 0
-30~15 °C -10
0~40 °C 15
-30~30 °C 10
0~20 °C 10
0~20 °C 6
1~240 Min 40
0~99 Min 8
10~120 Sec 60
-10~10 °C 3
-10~15 °C 0
0~480 P 100
0~480 P 100
0~9999 0
0~9999 0
EN| 21