• The room temperature may be high. >>>
The product will normally run for long peri-
ods in higher room temperature.
• The product may have been recently
plugged in or a new food item is placed in-
side. >>> The product will take longer to
reach the set temperature when recently
plugged in or a new food item is placed in-
side. This is normal.
• Large quantities of hot food may have
been recently placed into the product.
>>> Do not place hot food into the
product.
• The doors were opened frequently or kept
open for long periods. >>> The warm air
moving inside will cause the product to run
longer. Do not open the doors too fre-
quently.
• The freezer or cooler door may be ajar.
>>> Check that the doors are fully closed.
• The product may be set to a temperature
that is too low. >>> Set the temperature to
a higher degree and wait for the product
to reach the adjusted temperature.
• The cooler or freezer door washer may be
dirty, worn out, broken or not properly
settled. >>> Clean or replace the gasket.
Damaged / torn door washer will cause
the product to run for longer periods to
preserve the current temperature.
The freezer temperature is very low, but
the cooler temperature is adequate.
• The freezer compartment temperature is
set to a very low degree. >>> Set the
freezer compartment temperature to a
higher degree and check again.
The cooler temperature is very low, but
the freezer temperature is adequate.
• The cooler compartment temperature is
set to a very low degree. >>> Set the
cooler compartment temperature to a
higher degree and check again.
The food items kept in cooler compart-
ment drawers are frozen.
• The cooler compartment temperature is
set to a very low degree. >>> Set the
cooler compartment temperature to a
higher degree and check again.
The temperature in the cooler or the
freezer is too high.
• The cooler compartment temperature is
set to a very high degree. >>> Temperat-
ure setting of the cooler compartment has
an effect on the temperature in the freezer
compartment. Wait until the temperature
of relevant parts reach the sufficient level
by changing the temperature of cooler or
freezer compartments.
• The doors were opened frequently or kept
open for long periods. >>> Do not open
the doors too frequently.
• The door may be ajar. >>> Fully close the
door.
• The product may have been recently
plugged in or a new food item is placed in-
side. >>> This is normal. The product will
take longer to reach the set temperature
when recently plugged in or a new food
item is placed inside.
• Large quantities of hot food may have
been recently placed into the product.
>>> Do not place hot food into the
product.
Shaking or noise.
• The surface is not flat or durable >>> If the
product is shaking when moved slowly,
adjust the stands to balance the product.
Also make sure the ground is sufficiently
durable to bear the product.
• Any items placed on the product may
cause noise. >>> Remove any items
placed on the product.
• The product is making noise of liquid flow-
ing, spraying etc.
• The product's operating principles involve
liquid and gas flows. >>> This is normal
and not a malfunction.
EN / 24