Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ETHERNET PORT
•
The configuration and monitoring of the status of the
equipment is carried out through the Ethernet port. The
system has the following characteristics:
•
IPv4 support
•
M2M communication based on SNMP protocol to
configure, consult and update the equipment.
•
User authentication through user and Web pass
•
User authentication using LDAP
•
Consultation/modification of firmware, alarms and
configuration via remote from Web interface
•
DHCP Dynamic Host Configuration Protocol
•
Clock synchronization using SNTP protocol
In addition to the indicated characteristics, the system
has a function that allows the computer to boot with a
specific fixed IP address, by mean of button (Battery
reconnection) placed on the front plate
CHARGING CHARACTERISTIC
www.premiumpsu.com
Powering Your Challenge
INSTALLATION
•
Perform the installation of the equipment following the
connection drawings. The value of the charging current can
be changed from the default value via the Ethernet
connection.
For safety reasons it is required:
•
Make it accessible and easy to disconnect the equipment
from the mains.
•
In case of replacement of input fuse and / or battery fuse,
make sure to use one of the same features and perform the
installation with the equipment disconnected from the mains.
•
Perform the installation of the equipment in a safe
environment according to the regulations and directives of
electrical safety that apply in the country where it is installed.
•
Use a mains connection cable with a minimum section of
0.75mm².
5 / 18
31-05-2021
CA-656-1
Publicidad
Tabla de contenido
