Mounting - EcoFlow Home Panel Manual De Instalación

EN

6.2.2 Mounting

After you have placed the relay module inside and fastened the screws, attach both top and bottom
mounting brackets to the SHP as shown below.
13
2. (a) Plug in each relay module and seat firmly (it is
recommended to use the palm of your hand).
(b) Secure the relay module by tightening the two screws.
(c) Close the front panel, and secure the four screws.
(d) The Relay Module installation is complete.
(e) Repeat for all 10 relays. 10 relays must be installed even
if they are not all used
1
Position the SHP center to center to your main panel.
Please follow the local safe electrical clearance distance.