Lanberg PCS-0804-0050 Guia Del Usuario página 5

E. CAMERA SET INSTALLATION
1. Place the recorder at the target location.
NOTE: IT IS NOT RECOMMENDED TO PLACE THE RECORDER IN A BUILT–UP AREA, IT MAY NEGATIVELY AFFECT THE WIFI SIGNAL RANGE.
2. Screw the antennas to the recorder and to the cameras.
3. Then connect the monitor to the recorder using a VGA or HDMI cable (not supplied).
4. Connect the recorder to power using the dedicated power supply (48V 2A ). When power is applied, the device will start
booting up.
5. Connect the cameras to power using the dedicated patch cable.
6. Connect a mouse (not included) to the USB port.
7. Follow the on–screen instructions, the setup wizard will guide you through the initial system configuration. For a detailed
description of the wizard, see full user manual avaliable online on Lanberg.eu.
8. The menu of the recorder is opened with a right mouse button. The first time you open it, you will be asked for a login and
password. Default values:
Login: admin
Password: none (leave this field blank)
9. The recorder is ready for operation.
NOTE: WHEN YOU LOG IN FOR THE FIRST TIME, WE RECOMMEND CHANGING YOUR DEFAULT LOGIN DETAILS. PASSWORD SETTINGS
CAN BE FOUND IN THE SYSTEM SETTINGS
EN
Cameras
LAN7 LAN5
LAN8 LAN6
Recorder (NVR)
Router
Lanberg © 2015-2022
Monitor / TV
HDMI / VGA
LAN3 LAN1
LAN4 LAN2 WAN POWER AUDIO OUT VGA
RJ45 Cable
USB
HDMI
USB Mouse
Power
3