Use Of Cabinet; Cleaning And Ordinary Maintenance - EPTA Bonnet Neve Ampleo 2 EFFICIA Instrucciones De Uso Para El Usuario

Modello - Modèle - Model
Modell - Modelo - Modelo
Fabbricante - Constructeur - Manufacturer
Hersteller - Fabricante - Fabricante
Open door locking system
For loading an cleaning purpose the door can be
loked in open position by shifting the locking
system as shown by the arrow in the figure
("Fig. 18").
F
During the loading phase, if there are
sliding baskets (optional), they must
not all be removed at the same time
("Fig. 22").
9.8

Use of cabinet

L Regulation of the tension of the closing
spring of the door. If necessary, increase
the tension of the return spring, carry
out the operations of the "Fig. 19".
Lighting
The cabinet lighting is controlled by a switch on
the top right of the cabinet.
Thermostat/thermometer
A remote thermostat/thermometer
positioned on the top right of the cabinet to
control the temperature.
The remote thermostat displays the existing
temperature inside the housing and the
temperature is controlled using the dedicated
buttons.
N°DOC. UM000428 REV. "B" - 12/01/22
AmPLEO 2
Epta Spa - Via Mecenate, 86 - 20138 Milano (MI) ITALIA
Tel. 02/55403211 Telefax 02/55401023
9.9 Cleaning and ordinary
maintenance
Good visibility in the intervention area is
recommended, possibly using an additional
light source.
Cleaning the cabinet
Only use water at a maximum temperature of
65°C and household soap or neutral detergent
diluted in water.
For glass surfaces use only products for cleaning
glass. It is recommended to avoid the use of
water since it may deposit limestone on the
surface of the glass.
Never use:
• Abrasive sponges
• Flammable or abrasive products such as
alcohol, acetone or solvents
• Detergents
surfactants, lemon or vinegar (acetic acid)
F Do not wash or clean the top part of the
is
cabinet with water or liquids.
Clean all the external parts of the cabinet ONCE
A WEEK.
Clean all the internal parts of the cabinet ONCE
A mONTH, following the instructions below:
• Disconnect the power supply to the cabinet
using the wall-mounted main switch-
disconnector ("Fig. 23").
• Empty the cabinet, storing the goods in
cold rooms or refrigerators to maintain the
preservation temperature.
• Wait for the inside of the cabinet to have
reached the ambient temperature and
then clean
• After carefully checking that the inside of
the cabinet is completely dry, restart the
appliance by re-energising the cabinet.
• After a couple of hours, load the goods
again.
17/21
that contain non-ionic
IT
FR
EN EN
DE
ES
PT